1. PTMS magnetic separator The motor is overheating and its sound is abnormal.
The reasons for the overheating of the magnetic separator and its abnormal sound are as follows: 1. The bearing is poorly lubricated or seriously worn; 2. The fan blade is removed or worn. 3. Poor contact of the switch line, or break the line to run single-phase; 4. The voltage is too low.
2.PTMS magnetic separator overheating
The reasons are: 1. insufficient oil or poor oil quality; 2. Gear and worm wear too much, or meshing is not good; 3. Bearing poor lubrication or serious wear.
3.PTMS magnetic separator sounds abnormal during operation, the cylinder is stuck by obstacles, and even the cylinder cannot be rotated and the bottom box vibrates.
The reason is often stuck by the object of the bottom box, and then the magnetic block falls off, making the cylinder rattle, and the shell will be scratched seriously. At this time should stop maintenance, troubleshooting.
If any of the conditions change and PTMS magnetic separator equipment is still produced at the normal operating rate, it will affect the normal magnetic separation operation. Therefore, the magnetic separator operator should maintain contact with the upper and lower processes to achieve a mature understanding of the overall production.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
Dry-type PTMS MAGNETIC SEPARATOR bearing spare parts replacement skills
