When PTMS magnetic separator enters an obstacle, the lighter magnetic separator leaves a mark on the shell, while the heavier magnetic separator grabs the cut in the shell or skin. This phenomenon must be stopped immediately in order to remove the obstacles. In order to prevent large ore with ore into the dry magnetic separator, must be set up on the mine screen, prevent large and garbage into, and do a good job of cleaning.
The pumping line at the bottom may be blocked by sediment and working gaps due to calcium deposits. If you suspect the problem, stop and check. Sometimes the pipe doesn't get clogged, but in the work area, it does during working hours somewhere, there is no concentrate in the tank shell, so the high pressure water is a hole in the tank somewhere. To prevent the magnetic block from falling again, the PTMS magnetic separator magnetic system can be covered with thin copper during maintenance.
Dry PTMS magnetic separator has holes in the middle plate and microlight tube. The original light level rises sharply. When it is maintained at a high level, the oil drum makes a rattling sound and the skin of the oil drum will break. Mechanical failures, such as electric gear wear and motor failures, must be detected and repaired promptly.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
Why for PTMS Electromagnetic Separator magnetic roll the static balance test should be done after replacement
