The improvement of the washing water pipe for cylindrical wet PTMS magnetic separator is to open three rectangular holes on the side near the bottom of the cylinder (the size of the rectangle is determined according to the length of the tank). After opening the holes, you can see the bottom of the tank inside. The water pipe should be distributed 30 ~ 50 mm away from the bottom of the tank. Make three stainless steel plates 30 mm longer and wider than the rectangular holes (the excess part is to facilitate the installation of bolts.
This stainless steel plate is called a cover plate. According to the installation height of the PTMS magnetic separator flushing water pipe, a round hole with the same diameter as the flushing water pipe is made in the cover plate. The number of holes should be determined according to the length of the tank. The distance between the holes is preferably 200-300). Then weld a stainless steel tube with a length of 300 ~ 450mm at the stainless steel opening.
The length of the steel pipe inserted into the barrel is 200 ~ 250mm, and 100 ~ 200mm is left outside for connecting the hose. After the cover plate is made, it is bolted to the cylinder of the wet PTMS magnetic separator on the cylinder, and then the water supply pipe is connected to the stainless steel pipe on the cover plate with a rubber hose.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
Preparation work before implementing PTMS MAGNETIC SEPARATOR energy-saving retrofit
