PTMS MAGNETIC SEPARATOR It is mainly composed of four parts: cylinder, magnetic system, groove body and transmission part. The cylinder is welded from 2 to 3 mm stainless steel coil into a cylinder, the end cover is cast aluminum, with stainless steel screws and cylinder connected, the motor through the reducer, drive the cylinder for rotary movement. The magnetic system is open magnetic system, installed in the cylinder, the magnetic block is mounted with stainless steel bolts on the bottom plate,
PTMS MAGNETIC SEPARATOR The shaft of the magnetic yoke out of the cylinder, the shaft end is fixed with a turning arm, pull the turning arm can adjust the magnetic Angle, if the conveyor belt loose, do not panic first stop the chromium ore and close the watergate for treatment, so as to avoid the water level of the box rise, and cause the phenomenon of water.
In order to prevent the manganese ore PTMS MAGNETIC SEPARATOR conveyor belt loose, we must do a good job of daily inspection and maintenance work, to replace the new belt in time, do not let the manganese ore magnetic separator equipment in the state of overload operation. At the same time, we should pay attention to listen to whether the manganese ore magnetic separator equipment has made an abnormal sound in the process of work. If any abnormal device is found, we should stop in time to check.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com