PTMS Electromagnetic Separator The design and operation of the discharge water pipe require precise control. The pressure, flow rate and direction of the flushing water flow all need to be adjusted according to the properties of the concentrate and the working parameters of the magnetic separator. If the pressure of flushing flow is too large, some magnetic particles that are not fully absorbed may be washed away, resulting in the loss of concentrate, and if the pressure is too low, it may be impossible to effectively remove the concentrate from the cylinder surface.
The direction of the water flow is also critical, and the water pipe needs to be accurately aligned with the weakest magnetic force at the edge of the magnetic system to ensure that the concentrate can be smoothly discharged into the concentrate tank. If the fully magnetic roll is used, the unloading is performed through a brush roll. PTMS Electromagnetic Separator The material and structure of the brush roller have an important influence on the unloading effect.
The bristles of the brush roller need to have a certain hardness and elasticity, which can not effectively brush down the concentrate adsorbed on the magnetic roller, but also will not cause damage to the surface of the magnetic roller. The speed of the brush roller also needs to be matched with the speed of the magnetic roller to ensure the efficient completion of ore unloading tasks without affecting the normal operation of PTMS Electromagnetic Separator.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
The intelligent control system is applied to PTMS MAGNETIC SEPARATOR to solve the disadvantages of traditional methods
