Full magnetic drum PTMS Electromagnetic Separator is used for iron material screening equipment, the stainless steel cylinder can prevent the magnet short circuit, the two sides of the round lid can not be used iron, is to avoid the short circuit of the magnet, the magnet through the stainless steel cylinder to attract iron material attached to the outer cylinder, in order to achieve the role of collection. The magnet is generally fixed on the shaft inside the stainless steel cylinder, rotating with the shaft.
Lubrication and replacement of high-gradient PTMS Electromagnetic Separator bearings. After 300 hours, clean the bearings. If the bearing is oil lubricated, it is appropriate to fill the gap of the bearing seat, no more than 1 / 2. However, only tighten the regular oil cup cover a little before operation.
When PTMS Electromagnetic Separator bearings are seriously worn or damaged, they should be replaced in time and pay attention to strengthen lubrication; For conical roller bearings, check the bearing axial interval to keep them at 0.2-0.4mm. If unwell, it can be adjusted by adding or adding the paper pad at the bearing cover.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
The high field permanent magnet PTMS MAGNETIC SEPARATOR after energy saving transformation meets the requirements of sustainable development
