Pulp concentration is one of the main factors affecting the effect of PTMS Magnetic Separator. The overflow concentration of the machine. If the concentration of pulp is too high, resulting in high concentration of separation, will seriously affect the quality of concentrate. Because at this time, the concentrate particles are easy to be covered and wrapped by finer gangue particles, and the separation is not open, so that the grade is reduced.
If the concentration of slurry is too small, that is, the concentration of separation is too low, it will cause the increase of flow velocity and shorten the separation between pairs, so that some fine magnetic particles that should have had the opportunity to come up will fall into the tailings, which will increase the grade of tailings and cause losses. Therefore, pulp concentration should be adjusted according to the need. The adjustment in the PTMS Magnetic Separator is mainly based on the amount of water that is blown into the mine.
However, it is essential that the overflow concentration is determined according to the PTMS Magnetic Separator requirements. Slurry feeding concentration can not exceed 35%, generally controlled at about 30%, according to the cylinder, roll, brush roller, magnetic system, tank, transmission part of the actual situation to determine. The operator must do accurate judgment, accurate adjustment, but also do frequent inspection, frequent contact.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
The high-gradient PTMS MAGNETIC SEPARATOR adopts a modular design concept, which is conducive to installation
