The suitable value of the working gap shall be determined according to the specific production situation of each factory. The adjustment method is to add or remove gaskets on the four fulcrums of the PTMS magnetic separator frame support tank. Because the position of the cylinder is fixed, the tank body is raised after the gasket is added, and the working gap becomes smaller; Reduce the gasket, the working gap is larger.
The size of the working clearance should be uniform along the axial direction. If the size of the clearance at both ends is different, the slurry flow rate will be different. The end of the tank with large clearance may produce ore deposition or even blockage due to the low slurry flow rate. When one end of the PTMS magnetic separator is blocked, the observed phenomenon is that the surface of the tube at the blocked end does not absorb concentrate.
The accurate determination of the working gap can be carried out during the inspection of PTMS magnetic separator. Put a piece of plasticine near both ends of the bottom plate, install the tank, add the gasket, put down the tank, and take out the plasticine to measure the thickness of the squishing. Rough measurement can open the drawing holes at both ends of the tank, reach out to feel the gap, you can know its rough value.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
The intelligent control system is applied to PTMS MAGNETIC SEPARATOR to solve the disadvantages of traditional methods
