The use of a special pull is also exquisite, it needs to be closely connected with the roller magnet, to ensure that the roller magnet can be stably pulled out in the process of pulling, without causing damage to other parts of the PTMS Electromagnetic Separator. After unscrew the round nut, pull the roll drum out with a special pull. In order to ensure the balance of the rotor operation, pay attention to the complete set of replacement when changing the magnetic roller.
This is because the PTMS Electromagnetic Separator magnetic roll is accurately matched and adjusted during the production and installation process, and if only a single part is replaced, it is likely to destroy the balance of the entire rotor. The process of static balance test requires the help of special equipment to install the replaced magnetic roll on the test device, and to detect the balance in the static state to determine whether it meets the work requirements.
The static balance test shall be done after the magnetic roll change to stabilize the PTMS Electromagnetic Separator operation. If an imbalance is found, adjust until the equilibrium state is reached. Be sure to tighten the nut during assembly, which is the key step to ensure that the roll drum is installed firmly installed.
Contact: DELLA
Mob: +86-13929907491
No.9, Factory 2, Shijin Industry Park, Shishan Town, Nanhai District, Foshan City, Guangdong, China
Ph: +86-13929907491
E-mail: Sales@powtechina.com
the environmentally friendly ptms magnetic separator technology uses new materials and energy saving
